Optivision™

The Optivision™ pads is the newest generation of buffing pads used in final polishing step.

The Optivision 4540 has a dual pore structure; a combination of small pores dispersed amongst larger pores. This pore structure is advantageous over other finishing pads due to the increased number of contact points. The increase in contact area and number of contact points results in lower defectivity, increased removal rate, and improved surface finish.

Optivision™ Details

Base Material:

Poromeric

Shelf Life:

12 Months

Packaging:

Pads are packaged face-to-face (polish side to polish side) and sealed inside a plastic bag to ensure cleanliness during transportation. The bags are taped to the side of the box to prevent the bag from slipping and damaging the pads. Pads should always remain flat. Bending pads during handling can cause wrinkles in the PSA and premature delamination of the release liner.

Applications:

Copper CMP, Fused Silica, Germanium, TEOS

Similar Products

DF200FP5Politex™ HiOPC5350
Base Material PoromericPoromericPoromericPoromeric
Compressibility101213.7514
Thickness2555.16041

Complementary Products

Category - Polishing Pads

Handling Instructions

Apply only to a clean, dry surface at room temperature. If an appropriate solvent, such as isopropyl alcohol, is used to clean the platen after a pad removal, allow the platen to dry completely and return to room temperature before applying a new pad. Solvents remaining on the platen or an unusually cold platen will lower PSA adhesion.

When applying the pad to the platen, peel the release liner from one edge of the pad. Fold liner back approximately 2 inches. Align the pad with the edge of the platen and adhere. In one continuous movement, slowly peel the remaining release liner off the pad while pressing the pad down on the platen. The application should be smooth and uniform with even pressure from the pad mounting tool (such as a flat disk or hand roller).

Do not try to reposition pads with PSA adhesive.

Storage

Product should be stored and transported in the original packaging. The product should be stored in temperatures between 10°C to 24°C (50°F to 75°F) and <50% humidity. Exposure for six (6) months or less to conditions between -17°C to 48°C (0°F and 120°F) and/or at relative humidity of up to 100% will not impact the product performance as long as the release liner remains intact and attached to the PSA. If the product is exposed to temperatures and humidity outside the recommended conditions, it may still be acceptable for use. In all cases, the product should be allowed to return to normal room temperatures prior to use.

Disposal

Disposal in accorance with all applicable local regulations.

Contact Information

Fill out this form and we will get back to you with information regarding our products.


×