Challenge 543-HT

Slurry Additive for Suspending Non-Treated Abrasives (Single Pass)

CHALLENGE 543-HT is a medium viscosity lapping/polishing slurry additive which evenly disperses and suspends a variety of non-suspension-treated abrasives, including aluminum oxide, zirconium oxide, along with silicon carbide, boron carbide, synthetic and natural diamond, and garnet. Because of its superior suspension characteristics, CHALLENGE 543-HT reduces the amount of abrasive grain needed by up to 50%, while providing equal, and often greater, stock removal rates. 543-HT is particularly effective when using equipment with smaller slurry feed tubes, which constrict flow of high viscosity products. Benefits: • Flatter parts • No scratching • Less sub-surface damage • Easier post-lap cleaning • Increased removal rate • More consistent results • Reduced abrasive usage

Challenge 543-HT Details

Base Material:


Shelf Life:

24 Months


Product is available in 5-gallon pails and 55-gallon drums.


Ceramic, Fused Silica, Glass, Poly Carbonate lens

Similar Products

Challenge 540HTChallenge 550-HTChallenge 555-HT
Base Material WaterWaterWater
Specific Gravity11.01
Category - Lapping Additives

Handling Instructions

CHALLENGE 543-HT should be mixed with deionized water and abrasive using the following slurry formula: 77-82% water,15-18% abrasive, 3-5% CHALLENGE 543-HT. Use an agitator with a marine type propeller and a motor capable of 1750 RPM. Use a low shear dispense pump for feeding the mixed slurry onto the lap.

Disperse the abrasive with DI water at 1000 rpm for 3 minutes. Add 543-HT. Mix for approximately 10 minutes depending upon abrasive surface chemistry. Be careful not to suck air into the slurry when mixing. A small vortex should form at the surface of the slurry. Turn the mixer off, or to a maximum of 50 rpm.


Product should be stored in a temperature controlled environment. Prolonged exposure to temperatures at or below 32° Fahrenheit (0°C) is discouraged. Prolonged exposure to temperatures at or above 100° Fahrenheit (38°C) is also discouraged. In addition, material should always be sealed when not in use to prevent evaporation.


Dispose of in accordance with all applicable local regulations.

Contact Information

Fill out this form and we will get back to you with information regarding our products.